Rezman2115
Active Member
Here r the pruned pics
Attachments
-
634 KB Views: 5
-
571.5 KB Views: 5
-
683.9 KB Views: 5
Hey rez I know I'm the ultimate noob but I believe I read something where they state its best to pull the air across your light vs pushing pulling makes for optim function I'm gonna go look if I find it again I'll copy and paste stay greenOk so, I have a question to anyone willing.
I am planning to update my grow room this weekend when I transplant. This is what will happen...
Transplant into the final pots (5 gallon). I am planning for AT LEAST 6 more weeks of veg and there is a 7-9 week flowering cycle. They are indica dominant and I will be training (LST, topping, supercropping). I will be adding 4.5 cups of perlite to the batch of soil for all the plants (Fox Farms Ocean Forest). I am also hanging two "myCO2" bags for increase.
To the room itself I will be changing:
- I am lifting the filter so it is exhausting the hot air at the top of the room
- I am hanging reflective white sheeting on the walls
- I am switching the hood. I am switching to a Sun Star 6" air cooled reflector
- I am creating two new holes in the room (one in the front and one in the back) for ducting to connect to the new hood so fresh, cool air can move across the light
- One more 6" exhaust fan (rated 440 ppm) to blow the fresh, cool air past the light in the hood
So my questions are"
-Will this be too much at once for the plants? Or will all this induce good stress?
-Is transplanting straight into the 5 gallon pot (and expecting it to last) through another 5 months of life before harvest likely? If not, should I add an extra transplant (use a 3 gallon first and then go to 5 gallon a week before flowering) in between or at the end (expect to transplant into AT LEAST a 25 litre pot a week before flowering)
Thank you to all that will take the time for this.
Yea, i believe so as well. The reason I was thinking of pushing it was because the 6 inch ducting is flimsy aluminium. Pulling could cause a negative pressure in the duct work and could cause structural problems. I will be losing power, but pushing will give more consistency to the cheap duct work.Hey rez I know I'm the ultimate noob but I believe I read something where they state its best to pull the air across your light vs pushing pulling makes for optim function I'm gonna go look if I find it again I'll copy and paste stay green
Disregard last post noob mistake I read wrong sorry broHey rez I know I'm the ultimate noob but I believe I read something where they state its best to pull the air across your light vs pushing pulling makes for optim function I'm gonna go look if I find it again I'll copy and paste stay green
OK rez I think opinion vary cause proir I read to pull not blow but I just went to check somewhere and it said blow not pull so I have faith in your no how just wanted to share one love stay greenDisregard last post noob mistake I read wrong sorry bro
Well saidI meant leaks in the duct work outside of the tent/room. Inside duct work leaks are ok if they are pre light hood, after light hood will still circulate air. If you don't have a light hood design for cooling I would get one, it will reduce the shit out of your temps. No need to redo any or your layout, just install the hood inbetween the filter and fan. That's the only cooling method I use, no Ac, nothing and it keeps that 1000w light cool
Thank you very much!!Lookin good man! Keep it up! I'll be checkin in back and forth to see how all is going! Green Mojo brotha!