smokeabunny
Well-Known Member
Hi everybody i purchased some parts for a COB setup. Im just a little confused about how to wire it up also if its the right driver to power them.
So the driver is a HLG 240h-c1750b and i have 5 Cree CBX3950 36v? do i wire in series? if i do i think its not enough V? to my understanding i could run in parallel and have enough but i was advised its unsafe. not sure if its still unsafe if i put fuses or resistors on it. i was told. by the vendor it was the right driver to power 5 of those cobs. and then i watched Growmau5 videos and now im in doubt!!! pls help a fella out
So the driver is a HLG 240h-c1750b and i have 5 Cree CBX3950 36v? do i wire in series? if i do i think its not enough V? to my understanding i could run in parallel and have enough but i was advised its unsafe. not sure if its still unsafe if i put fuses or resistors on it. i was told. by the vendor it was the right driver to power 5 of those cobs. and then i watched Growmau5 videos and now im in doubt!!! pls help a fella out