Alphonso OG
Well-Known Member
It begins
First grow in any form! Chime in if you feel you can help.
- Thread starter Destroyer of chairs
- Start date
Destroyer of chairs
Well-Known Member
Link to your journal?
Alphonso OG
Well-Known Member
32 Gallon Brute Garbage Can Air Pot AKA ED 209
Ok here we go folks. A Diy 32 gal brute trash can air pot. I cut 3 inch and 1/2 holes cut all around it. Window screen mesh inserted inside to secure the hydroton and coco while air pruining. the strain is Purple Afghan Kush from Dinafem. Im using Raw solubles nutrients will be switching to...
www.rollitup.org
Destroyer of chairs
Well-Known Member
Noticed bottom growth are clawing and some of the leaves burned/dead/ tips. Hmm what is causing this? Read it can be it taking up too much nitrogen?
Alphonso OG
Well-Known Member
If your ppms are in line i doubt nitro. What type of light are you using? Those little inner nodes dont develop well without a decent light exposure.
Destroyer of chairs
Well-Known Member
But my calmag contains some nitrogen right? And I went half strength with that one, compared to 1.5/4 of base.
I use platinum led p300( only veg switch on which Is 90 watt out of the wall)
Switching to qb 240w 3500k this week when room is finally ready.
Can they get these symptoms from lack of light? Cause they almost don't get any, very hidden beneath big leaves.
I use platinum led p300( only veg switch on which Is 90 watt out of the wall)
Switching to qb 240w 3500k this week when room is finally ready.
Can they get these symptoms from lack of light? Cause they almost don't get any, very hidden beneath big leaves.
Alphonso OG
Well-Known Member
Yes it can. Thats why I LST so much. Tie some branches down and give them sum light they will grow properly. I remove fan leaves that block potential flower sites.
Destroyer of chairs
Well-Known Member
Hmm OK I think maybe this is the cause then. But in gonna make these mothers. What is best approach for that, topping them or just letting them grow and cut fan leaves blocking stems/flowers?
Destroyer of chairs
Well-Known Member
Ps. I want to get clones up and running as soon as possible as well.
Alphonso OG
Well-Known Member
I wouldnt take clone until shes in the best healthy state.
Destroyer of chairs
Well-Known Member
That goes for topping aswell?
Alphonso OG
Well-Known Member
I use twine and tape them to the sides of the buckets like so. I dont do topping but i should.
Destroyer of chairs
Well-Known Member
Think stem will be hard to bend like that now. Do I dare supercrop it?
Alphonso OG
Well-Known Member
Always add silica for stressful situations. Now ill tie a not around the branch then ease it down til put tape on it. Some will be more firm so be gentle and a little bend. You just want to expose those sites.
Destroyer of chairs
Well-Known Member
Don't have silica :/ OK ill try lst then thx for tips.
Alphonso OG
Well-Known Member
Also its make the branches soft and bendy.
Destroyer of chairs
Well-Known Member
Ok don't laugh, first attempt to bend/lst 
Picture taken from center of light.
Picture taken from center of light.
Attachments
Destroyer of chairs
Well-Known Member
Its the next thing I'm ordering for sure.
Alphonso OG
Well-Known Member
Ill pull off those faded leaves on both plants. They wont comeback and call it days work.Ok don't laugh, first attempt to bend/lst
Picture taken from center of light.
Destroyer of chairs
Well-Known Member
All or just those 4 worst cases?