CLU048-1212C4-353H5M3-F1 with HLG-185H-C1050B

Hey guys I was wondering if what I had in mind would be a good idea for a 3.3'x3.3' tent (1m2 tent).

I would like to run 2 HLG-185H-C1050B (runs at 190V) with 5 CLU048-1212C4-353H5M3-F1 (Fv≃34V) cobs each.

That would be, if I'm not mistaken, that each cob would be runnig at 38V giving 39.9W/each giving a total of 399w at the wall.

I would be running D133 x H70 mm pre-drilled pin fin heatsink in each cob just to make sure heat is not a problem thus providing even more efficiency. I like the efficiency this setup provides as I think it might be near 60%.

Idk guys do you guys think this is a good set up for a 1m2 tent? I would veg and flower in the same tent dimming the cobs during veg. If you think there is a cheaper way to get the same numbers or just a better setup please do not hesitate I'm here to listen you all.

Thank you very much.

Arnau.

I'll add @CobKits

I'm just building my kit using the same bulbs but I will be running 6 CLU 048 1212 V6 with one ELG 240 C1050b. My tent is a 90x90x170cm.

You should post this in the LED subform in the indoor growing section. Lots of knowledgeable LED folks there to help out.

brewbeer said:

You should post this in the LED subform in the indoor growing section. Lots of knowledgeable LED folks there to help out.

Click to expand...

Do i copy the post and repost it there? Thx

faultfiction said:

I'm just building my kit using the same bulbs but I will be running 6 CLU 048 1212 V6 with one ELG 240 C1050b. My tent is a 90x90x170cm.

Click to expand...

That is a good set up with good efficciency but I think 250w at the wall is not enough for a 90x90cm but I could be wrong. It is not a bad choice I just think that you could fit a little more Watts.