Wolverine97
Well-Known Member
Sounds like you are flushed.
The proper way to read your pH is by doing a slurry test.
Grab as much loose coco as you can from as low as you can and put it in a small cup. Add just the slightest amount of filtered water (distilled is ideal) to the coco so you can make a kind of slurry with it. Put your pH probe right down into the slurry and test that pH.
This is how Canna recommends testing the pH of Coco.
Personally I always notice the pH is a few points higher, no matter what, with coco. Usually my pH runs off at around 6.3ish when I use a 5.8pH solution. I don't see pH issues in coco very often unless the solution being used is WAY off.
I second this, though I would further stress the importance of using pure water for a slurry test. RO or distilled are the only accurate ways to do it, as any alkalinity at all will skew your results one way or the other.