tpsmc
Well-Known Member
I built an aeroponic system that uses a 400 gph submersible pump. All my plants seem to be doing just fine, but I have been monitoring the temp of the reservoir (9 gallon) and it reaches 100 degrees when the pump is running. Currently I have the pump on a 15 on 15 off cycle (I have a CAP ART-dne on order), what could happen if the temps stay too high, also could I cut the cycles down to 15 on 30 off or is that too much dry time for an aeroponic system? I also noticed a PH jump from 5.7 to 6.5 in 2 days. I balanced it back down not sure what caused the jump as I haven't added additional nutes and the res level looks to only be down an 1/8th of an inch since filling it up.
Also I dont want to spend the 300 - 400 on a chiller + additional electric to run it. I am looking for a worst case leaving the temps where they are until I get my CAP (4 or 5 days) which I hope will solve the problem.
Also I dont want to spend the 300 - 400 on a chiller + additional electric to run it. I am looking for a worst case leaving the temps where they are until I get my CAP (4 or 5 days) which I hope will solve the problem.