iismokeganja
Member
dddddddddddddddddddddddddddddddddd
Hi! do you have fans at all? Where is all the air going to be exhausted to? If smell might be an issue for you then you should try to have that figured out before flowering anything. Things are looking nice so far! You should get something very nice with that setup.this is my first grow...so any help or advice on making my room better is greatly appreciated. i want to do a scorg but i dont know the dimension i should build it. i have read the tutorials. i understand the general idea but what size should i make it for my room i have a 400 watt mh/hps i can only run it at 75% so i dont over heat my grow area is (4feet and 4inches wide) (2feet 4incheslong) (5feet 7inchestall) this is just the side of the closet i am using. if i used the whole thing i think it is 5w 4l 5.7h
I like how you started off with a good light.
My area and light is very similar to yours. What I did was cut a circular hole in the ceiling of the closet and ran an inline fan blowing the heat up into the attic. Right now I have a DIY carbon filter attached to the inline fan blowing into the attic. I added two holes in the low section of the door and attached a computer fan on each hole to blow air into the closet. So holes in the door bring air in, inline fan with filter blowing into attic.
I covered the holes in the door with a register louvre.
Similar to this.
View attachment 2907511
You might want to put a piece of wood under your ballast so it doesn't sit on the carpet.
Good luck
I use a 4 inch inline fan. They have 6,8,10 etc but I went with the 4 because the drill bit, called a hole saw, is easier to work with imo. I can also use the 4 inch saw for holes when making DWC hydro tanks. Just convenience really.Thanks brotha that is actually the exact thing I needed and was looking for. For my exhaust. I wasn't sure if they made something like that. What size inline fan should I be using? When I do get a carbon filter.