Irrigation manifold (orbit) question
- Thread starter Jjgrow420
- Start date
bk78
Well-Known Member
So how exactly does the water flow to the single line ran to the reservoir w
Start a journal about it
Jjgrow420
Well-Known Member
Maybe I'll trade the fluid inside in the classified section. Might make a good foliar spray who knows
Organic
Nope_49595933949
Well-Known Member
I'll add it to my piss tea.
Jjgrow420
Well-Known Member
And the 3x3 'tester' tent
Should have put a better bulb in my cmh. Plants stretched hard but it's alright. Changed it after a week or so after 12/12 and added led.
Tents just a strain tester anyways 315w cmh sunmaster full nova wx and a 100w spiderfarmer
Needs some defol and attention lol
Should have put a better bulb in my cmh. Plants stretched hard but it's alright. Changed it after a week or so after 12/12 and added led.
Tents just a strain tester anyways 315w cmh sunmaster full nova wx and a 100w spiderfarmer
Needs some defol and attention lol
Jjgrow420
Well-Known Member
What is everyone using for table drains? I have rain barrel bulkhead fittings, but they seem to leak from the threads. Maybe try a better quality bulkhead... Was looking at ebb and flow drain kits but not sure if the size will work. Looks like a 1/2" drain but I need a bit bigger
Nope_49595933949
Well-Known Member
Have you tried thread tape?
Jjgrow420
Well-Known Member
I did tape them. I generally tape all my threads. It leaks less, but still leaks
Nope_49595933949
Well-Known Member
That's fustrsting.
Nope_49595933949
Well-Known Member
Worth a shot, and some plumbers puddy. What about a sink drain?
Jjgrow420
Well-Known Member
Yea it's driving me nuts. I did buy the bulkheads from amazon (china) so I'm sure they aren't the greatest quality. I have that hooked up to garden hose end, into a 5/8" hose.
Jjgrow420
Well-Known Member
Thought of this but the size is too large. Haven't been able to find a small one that'll fit into the tables low spot. Also I'm limited to about 5" underneath the table. I have a 90° elbow on the bottom that kicks it horizontal without bending
Jjgrow420
Well-Known Member
lyfLux 3 pcs 1/2 inch Female 3/4 inch Male Soild Brass Water Tank Connector Theaded, with 9 Rubber Rings for Water Tank, Bathtub, Water Bottle, Pool, Faucet, Accessories https://a.co/d/aH0OH7D
DANNER MANUFACTURING Ebb & Flow Kit #49922, Black https://a.co/d/bJfBAFO
DANNER MANUFACTURING Ebb & Flow Kit #49922, Black https://a.co/d/bJfBAFO
J. Rocket
Well-Known Member
silicone seals well, fills voids. just have to let it sit for a day to cure.
for metal threads (like brass) I use pipe dope.
gr865
Well-Known Member
Did the bulkhead fitting not come with gaskets? Should be one inner and one outer gaskets.